My ambient frequency response

 

Half my Studio Space.

 

Here's me set up!!

 

Yeah, until you run out of rizzlas...

 

cool studio bro, wanna do reggae collab?

 

Last edited: Mar 21, 2022

Isn't this the ECG of a producer when he hears his chosen snare sounds like Shit?

 

Maybe when he reads some shit on this thread

 

Shutup, I was first!!!!

 

eh whatever I don't like reggae anyway, much more prefer techno if you know what I mean

 

Just because my studio shows the best herb on the planet!!! Why believe we like reggae! just because rastafari smoke the bud!! Everybody
has smoked a bud in there life time!!

 

Current condition.
Due to many reasons (one of them being no space available on the floor due to chunks of Absorbers, like the Speaker stands are huge absorbers, the box in between the stands are a 4'×3'×2' absorber. The whole room acts as a low Q membrane absorber due to the room inside room structure with the Gypsum on Steel studs (you can understand that from the Decay plot and Waterfall plot I shared earlier, that the room is extremely absorptive, even down to sub 20Hz region). The grey looking things on the walls are another set of absorbers (1" PU Foam + 4" Rockwool and 1" air gap on top of Gypsum board). I had Airgap and Rockwool between concrete wall and the Gypsum wall.


Now, you can see Panels on the desk as well. You can see a free space between two blue desk absorbers and behind the Red Handrest. It is for my 43" 4K DIY Touchscreen (Baaically I will add IR Overlay panel on top of a Sony 4K display). The switch boards will be hidden behind the Screen.
I like the switches for the speakers, Driverack etc on the Table.
Also, you can see, the Center line is clearly marked on everything (Width Center).

 

Nice! Looks a little bit like a lucha libre arena
Isn't the screen to far away from the keyboard for you?

 

The screens you can see are secondary (the on in the middle and up top) and tertiary (one on the right).
Secondary screen is for secondary works, like viewing the Mixer, may be accessing Chrome or Whatsapp etc if needed. The tertiary screen is for Process audio decibel (one can use Izotope Insight as well). The primary screen has not been installed yet. It will be in the middle portion of the table that is empty as of now.

 

I know the desk space looks weird. But I had to do this TO COMPLETELY ELIMINATE DESK REFLECTIONS.

My ETC, looks like one single peak and then nothing more than -30dB. So basically a true RFZ. This is why I put panels (5" panel; 1" foam wrapping 4" rockwool) on the desk.

 

Oh man, your setup looks killer! Not like with what i was grown up. I think if i would take only one hit i would be dead, or at least turn into a green frog

 

Nice work

 

Thank you

 

I now need to install the IR Touch Overlay panel on top of the screen.

 

Congratulations on your new studio!
Who do you work for or in other words what do you work on?

 

I have already done one time. was not so easy that everything stays clean. I had a mess with the adhesive.
Good luck!