I wasn't sure where to post this.

Before I start, in case anyone wonders, No, I do not want to sell anything.

I have always had an interest in synthesisers and sound creation. Whenever I had a bit of extra cash over my life I bought a piece of gear.

Now for a variety of reasons I have never had a location where I could actually set up or use any of it, eg. Living on a narrowboat. In fact it has taken all my ingenuity to just store it somewhere over all this time.

Consequently I have Synths that are in New or Mint condition some of which have only ever been turned on once to check they work, such as JP8000 x 2, Supernova 2, Nord Lead 2x, Yamaha an1x, Access Virus TI2 Keyboard, Korg Karma, Korg MS-2000 Rack and Keyboard, Korg Wavestate, Waldorf Blofeld and Pulse 2 Modules, OB6, Moog Sub37.

I have KRK VXT8 Monitors, unused, brand new in their boxes, New Focal Alpha 65 Evo, Secondhand Spirit Absolute 4P in excellent condition.

Mackie 1642 VLZ3, Mint unused, Soundcraft Spirit FX16 II secondhand, Steinberg UR28M audio interface.

Then there's a whole host of pedals and boards, mostly brand new in their boxes.

Many leads of all descriptions.

Furman PL PRO DMC E power conditioner, FURMAN PS-8RE SERIES II.

19" Outboard: Tascam LM-8ST Line Mixer, BSS FCS 966 graphic equaliser, TC Electronics Fireworx, Ashly CLX-52 Dual Channel Compressor Limiter, TC ELECTRONIC M3000, Yamaha SPX 2000, LEXICON MPX-1, Roland SRV-3030, Tc Electronics m one xl, vitalizer, Lexicon MX400, Quadraverb 2.

So I have all this gear some of which is 20 years old and maybe older that is essentially new and unused for the majority.

My questions are these...

If I actually do ever get to set this stuff up are there any precautions or advice people would suggest before I turn this stuff on?

Are there known issues with kit that just sits in an attic? Will it have degraded over time? Will speaker cones still be OK for instance?

I have read about some sort of Red gunk stuff coating KRK boards in VXT monitors that cause condensation issues once they start getting used. Should I clean this gunk, if it's there, off first?

Will capacitors likely need changing before I turn this stuff on?

Are power supplies likely to still work or can I expect a smoky experience?

I have listed the kit so that any known specifics for that piece of equipment can be perhaps be identified.
Any and all advice gratefully received because I have no idea, and do not want to experience blowing up one piece of kit after another. I do have the ability to do my own basic DIY soldering stuff. I do not have wads of cash.

I'd ask AI except my repeated experience with AI and hardware is you have to know more than the AI because it will lead you astray almost every single time, multiple times.

 

Sounds like you've got a lot to look forward to, stay positive! As long as your kit's been well stored (i.e. not damp or extreme temp variations) you should be ok. No matter, at some point you're gonna simply have to turn it all on. I personally would power-up each bit of kit on its own the first time, just to keep the anxiety levels manageable.

Once you've established everything's hunky dory, you're more likely be worrying about your electricity bill than anything else.

 

Last edited: Nov 17, 2025 at 11:25 PM

Absolutely harrowing

 

The only thing that could happen over time is a leaky cap or battery.
But to be fair thats not to be expected.
Music gear is way better built than most consumer electronics.
Like if you have an OG XBox chances are high that certain caps are leaking now.
Destroying the mainboard if not dealt with early.
The problem here is not that some current damages other components when turning on, its that the electrolyte damages the circuit board by dissolving parts like some acid (the bad one, not the fun one).
Same with batteries needed to store settings.
If you ever owned an Amiga you might know its RAM expansian had a battery backed up clock. Those batteries were soldered on.
And they started leaking about 20 years ago dissolving the circuit boards.
The thing you were referring to with "gonna explode when turning on?" is most likely an experience you had with the trusty C64 and its infamous power adapters. The diodes were way too weak and went bad over time making the rectifier non existant, thus boosting high AC into the computer.
BUT: Don't be paranoid now. These are examples of bad design and cheap components to make a penny more on every sold unit.
A cap going bad does not mean it has to leak. The amp I like most is from Yamaha and there is one cap in there that is going to break 100% now.
But it doesn't leak. There are several sites explaining what to order, how to find it on the board and for about 20c anyone can repair it.
and repaired ones are going to work for a little eternity.

 

The knobs might get a bit crackly. That was an issue in the pre-dawn of audio gear right up to the middle ages in the 80's. Go for it. Or sell it all for a PC and some bundles of plugins. You'll love the savings on space. You don't need most of that old stuff these days, if you just want too write music. I bet it is awesomely shiny and new looking...