I have installed montage ESP on windows 11 and it is fully operational, either when using presets or additional third party libraries (these were meant for motif XF and the conversion works). But there is one large bank that I have created for my motif XF, it is based on waveforms (multisamples) that I have compiled and it has been saved as an X0A file. Montage ESP converts it without difficulties but none of the resulting performances is audible when I play them. The settings for each performance look correct. I have tried to select or deselect the keyboard for the part, change the receiving channel, and change the levels. I am certain that the waveforms are correctly loaded because, if I engage an arpeggio, it plays the part with the expected sound. But if I do not activate the arpeggio, I do not get any sound. When I play the factory voices contained in the same bank, I do not have any problem.

Has anyone run into similar problems with ESP ?

 

i had a problem playing some element sounds
next to the PAN on each element theres a
SW (switch) it was greyed out
switched on and got sound

not sure if this helps
but what beast this thing is.