Greetings!

My old Mackie Interface has gone down the drain, and i bought an audiofuse studio
as a replacement and improvement.
But before installing it, i wondered about the 100+ Songs i made in Studio One v4
with the Mackie: Do i have to open every single song to change the ins and outs
on every track to the ones on the arturia?
Or is there some magic function in SO4 for a general replacement of the in/out
configuration for all songs at once?

 

Basic Midi Setup - New Keyboard/ Control Surface / Instrument
https://support.presonus.com/hc/en-...Keyboard-Control-Surface-Instrument-Faderport

 

As i understand it, this does not include audio interfaces and their respective ins and outs.

 

It depends how you normally use your DAW's options for your interface. If you have your interface selected as a system wide device, you would have set your DAW settings for audio to "system default". If you explicitly set it to your Mackie, then you will have to change it to your new interface.

 

1. Unplug your old USB audio interface
2. Uninstall the old Mac software
3. Install the software for your new AudioFuse Studio
4. Connect the cables from your new interface to your computer. Usually USB!
4. Open the "Audiofuse Control Center" and set your bitrate etc. data. https://dl.arturia.net/products/afcc/manual/AFCC_Manual_2_1_3_EN.pdf
5. Start Studio One - on the home page you can "select the audio device" and check the settings.

EDIT: In my opinion with the new installation, the old routings are automatically overwritten with the new audio interface and there is no need to reset all 100 settings manually.

 

Last edited: Nov 18, 2024 at 6:26 PM

@Radio, mate, read the OP, you haven't understood the problem (again).

 

But I already understand, in my opinion with the new installation as described in the previous posting, the old routings
are automatically overwritten with the new audio interface and there is no need to reset all 100 settings manually.