Hi everyone

I need some clues as to how to get this to work , it installed OK

but to tell you the truth I cannot figure out what it does

can someone tell me how to get an audio signal into and out of it

Thanks

 

Hi, your title says what it does. In short, you can edit/save sounds/presets from an AdrenaLinn multi-fx hardware,
and recall them in aforementioned yoke. There is no way nor need to get an audio signal trough the editor,
since it communicates to hardware via MIDI. I've never used that particular editor, but am an owner of Mopho and Evolver ones,
and they all (SoundTower) share the same frame - click the Midi tab/Midi Setup.
In MIDI Setup, select both MIDI In and MIDI Out ports where Adrenaline is connected - your soundcard's MIDI.
(MIDI in (MIDI Controller) - here you can show editor your MIDI controller you want to use to control AdrenaLinn.)
Cheers!

 

Thank you 8-bit for your help


played around with it , used virtual midi cables to connect it to reaper and back again
but could not really, get it to do anything, recognized the virtual midi cables and seemed
to get a midi signal in and out but no go

just wanted to play around with it

Thank you again for pointing me in the correct direction :dancing: *yes*



Thank you Studio 555 I understand now , the files are in the gear

 

@ Korgrog,

'8-bit' is totally right ! *yes*

And what you really need to use and play with that specific Sound Editor is the following piece of gear :




Some info about that 'AdrenaLinn II' can be found here :

Roger Linn 'AdrenaLinn II' Support Page